17.Stay alert. Watch what you are doing. Use common sense. Do not operate a power tool when you are tired.
18.Check for damaged parts. Before using a tool, check that there are no damaged parts. If a part is slightly damaged, carefully determine if it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, proper mounting and any other conditions that may affect the operation of the tool. A part that is damaged should be properly repaired or replaced by an authorised service facility, unless otherwise indicated in this Instruction Manual.Defective switches must be replaced by an authorised service facility. Do not use a tool if the switch does not turn the tool on and off correctly.
19.Guard against electric shock. Prevent body contact with grounded objects such as water pipes, radiators, cookers and refrigerator enclosures.
20.Use only approved parts. When servicing, use only identical replacement parts. Use an authorised service facility to fit replacement parts.
Additional safety rules for dust collectors
When using the dust collection system, follow basic safety precautions including the following.
•Do not vacuum, or use this Dust collection system near flammable or combustible liquids, gases, gasoline or other fules, lighter fluid, cleaners,
•Do not vacuum anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
•To avoid health hazards from vapors or dust, do not vacuum toxic materials.
•Do not use or store near hazardous materials.
•Do not use outdoors or on wet surfaces.
•Put unit on a stable surface.
•Route vacuum hose and electric cord out of traffic areas.
•To avoid injury from accidental starting, unplug power cord before changing or cleaning filter/dust bag or chip bag.
•Do not use without filter/dust bag and/or chip bag in place.
•Turn off controls before unplugging.
Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Components
The DC750 dust collector is supplied with the following components:
•Dust collector
•3m x 100mm diameter hose
•Hose clamps (x2)
•2 way adaptor
•Plug for 2 way adaptor
•Wheel castors (x4)
•Dust bag
•Instruction manual
5
