Trouble shooting
WARNING. Turn the on/off switch to the off position and unplug the tool from the power supply before performing trouble shooting procedures:
Trouble | Problem | Suggested remedy |
|
|
|
Dust collector | Power cord not plugged in | Ensure that the cord is connected to the power supply |
will not start | Power fault, fuse or circuit | Check the power supply |
| ||
| breaker tripped |
|
|
|
|
| Cord damaged | Use authorised service centre to repair or replace |
|
|
|
| Burned out switch | Use authorised service centre to repair or replace |
|
|
|
| Faulty motor | Use authorised service centre to repair or replace the motor |
|
|
|
Dust collector | Inlet cover is blocked | Turn off the dust collector and remove the saw |
suction is poor |
| dust/wood chips blocking the inlet |
| Outlet cover blocked | Turn off the dust collector and remove the saw |
|
| dust/wood chips blocking the outlet |
|
|
|
| Hose blocked | Remove any saw dust and wood chips that may be blocked in the |
|
| hose. Where the double adaptor is being used remove the plug on |
|
| the second 35mm inlet to increase the air flow. |
|
|
|
| Dust bag is over half full | Empty dust bag |
|
|
|
Vibration or | Loose parts | Check to see that all screws are secure and tightened |
abnormal noise | Moving parts excessively worn | Use authorised service centre to repair or replace |
| ||
|
|
|
10
