4.Now that the air filter housing cover has been removed, proceed to remove the air filter by pulling it out towards you.
5.Wash the air filter in solvent or kerosene and allow to dry.
6.Lubricate the filter using clean motor oil.
7.Thoroughly squeeze the filter removing excess oil.
8.Replace air filter back into the
engine (Fig. W). | W |
9.Reinstall the air cleaner cover by inserting the lower tab in the bottom latch on the air filter housing. Continue to replace the air cleaner cover by making sure that the top tab has been secured into the top latch (Fig. X).
X |
| Y |
|
|
|
10.Secure the maintenance cover (5) back onto the side panel of the generator, and tighten the cover screw securely (20) (Fig. Y).
IMPORTANT. Never run the engine without the air filter element in place.
Cleaning
1.Keep your machine clean. The outside of the machine can be cleaned using a damp soft cloth with a mild detergent if required. Never use water to clean the generator as it may cause damage to internal parts.
2.Some maintenance products and solvents may damage the plastic parts; these include products containing benzene, trichloroethylene, chloride and ammonia.
3.Use a vacuum to clean air inlet and outlet louvers of the alternator.
4.Take special care to keep the ventilation inlets/outlets free from obstruction; cleaning with a soft brush followed by a compressed air jet will usually be sufficient to ensure acceptable internal cleanliness.
5.Wear eye protection when carrying out cleaning.
Repairs
Only an authorised service centre should repair the generator.
CAUTION. Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent on a damp cloth is recommended.
Transportation
When transporting the generator please make sure that it is in the upright position at all times, with the fuel air breather on top of the fuel cap in the off/closed position.
General inspection
Regularly check that all the fixing screws are tight. They may vibrate loose over time.
17
