Mitre table locks |
| |
D | ||
The mitre table locks (15) | ||
| ||
are used to lock the table |
| |
at the desired mitre angle |
| |
(fig. D). |
|
The mitre saw cuts from 0° to 45° both left and right. To adjust the mitre angle loosen the mitre table locks and
rotate the mitre table to the desired position. The mitre table features positive click stops at 0°, 15°, 22.5°, 30° and 45° for quick setting of common mitre angles.
WARNING. Be sure to tighten the mitre table locks before making a cut. Failure to do so could result in the table moving during the cut and cause serious personal injury.
Bevel lock |
| |
The bevel lock (7) is used to | E | |
set the blade at the desired | ||
| ||
bevel angle (fig. E). The |
| |
mitre saw bevel cuts from |
| |
0° to 45° to the left. To |
| |
adjust the bevel angle loosen |
| |
the bevel lock and adjust |
| |
the saw arm to the desired |
| |
bevel angle. |
|
WARNING. Be sure to tighten the bevel lock before making a cut. Failure to do so could result in the saw arm moving during the cut and cause serious personal injury.
Spindle lock button
The spindle lock button (18) | F |
prevents the blade in the |
|
saw from rotating (fig. F). |
|
Depress and hold the spindle |
|
lock button while installing, |
|
changing, or removing the |
|
blade. |
|
|
|
Rotating lower |
| |
G | ||
blade guard | ||
|
The rotating lower blade guard (5) provides protection from both sides of the blade (fig. G). It retracts over the upper blade guard (4) as the saw is lowered into the workpiece.
Turning on and off | H | |
1. To turn the saw on depress | ||
| ||
and hold the on/off trigger |
| |
switch (16) (fig. H). |
| |
2. To turn the saw off release |
| |
the on/off trigger switch (16). |
| |
|
|
Turning on the REDEYE® laser line generator
The REDEYE® laser line
generator emits an intense I narrow beam of pure red
light to guide you as you cut. It improves operator cutting vision, enables faster set- up, increases accuracy and improves safety. To turn on the laser line press the laser light on/off switch (25) (fig. I). To turn off the laser
press the laser light on/off switch (25) one more time.
Setting the table square with the blade
1.Make sure that the electrical plug is removed from the power point.
2.Push the saw arm (1) down to its lowest position and engage the release knob (2) to hold the saw arm in the transport position.
11
