3.Loosen the mitre locks (15).
4.Rotate the table (12) until the pointer is positioned at 0º.
5.Tighten the mitre locks (15).
6.Loosen the bevel lock (7) and set the saw arm (1) at 0º bevel (the blade at 90º to the mitre table). Tighten the bevel lock (7).
7.Place a set square against
the table (12) and the flat J
part of the blade (fig. J).
Note. Make sure that the | 90 |
| 0 |
square contacts the flat |
|
part of the saw blade, not |
|
the teeth. |
|
8.Rotate the blade by hand and check the
at several points. | K |
9.The edge of the set square and the saw blade should be parallel.
10.If the saw blade angles away from the set square, adjust as follows.
11.Use an 8mm wrench or adjustable wrench
to loosen the lock nut | L | |
securing the 0° bevel | ||
|
13. Loosen the Phillips head screw holding the pointer M of the bevel scale (8)
and adjust the position of the pointer so that it accurately indicates zero on the scale. Retighten the screw (fig. M).
14.Retighten the bevel lock
(7) and the lock nut
securing the 0° bevel adjustment screw (10).
Note. The above procedure can also be used to check the angle of the saw blade to the table at 45º bevel angle. The 45° bevel adjustment screw (9) is on the opposite side of the saw arm.
Setting the fence square with the table
1.Make sure that the electrical plug is removed from the power point.
2.Push the saw arm (1) down
to its lowest position and N
engage the release knob (2) to hold the saw arm in the transport position.
3.Loosen the mitre locks (15).
4.Rotate the table (12) until the pointer is positioned at 0º.
5.Tighten the mitre locks (15).
adjustment screw (10). |
Also, loosen the bevel |
lock (7) (fig. K). |
12.Adjust the 0° bevel adjustment screw (10) using a 4mm hex key to bring the saw blade into alignment with the square (fig. L).
6.Using a 5mm hex key, loosen the two screws securing the fence (11) to the base (fig. N).
7.Place a square against the fence (11) and alongside the blade (fig. O).
8.Adjust the fence (11) until it is square with the blade.
O |
90 |
9. Tighten the screws securing the fence (11).
12
