Using the REDEYE laser line generator
WARNINGS. Do not stare directly at the laser beam. Never aim the beam at any person or an object other than the work piece.
Do not deliberately aim the beam at personnel and ensure that it is not directed towards the eye of a person.
Always ensure the laser beam is aimed at a sturdy work piece without reflective surfaces. i.e. wood or rough coated surfaces are acceptable. Bright shiny reflective sheet steel or the like is not suitable for laser use as the reflective surface could direct the beam back at the operator.
Only turn the laser beam on when the work piece is on the tool.
1.Mark the line of cut on the work piece.
2.Adjust the bevel angle, rip fence and upper blade guide as required.
3.Switch on the laser beam using the laser light on/off switch (7).
4.Align the laser beam with the line on the work piece.
5.The laser beam can be aligned to be parallel with the line on the work piece by adjusting the laser line.
6.To start the saw, press the green 'ON' button.
7.To begin the cut guide the wood into the moving saw blade.
8.Use only enough pressure to keep the saw cutting. Do not force the cutting, allow the blade and the saw to do the work.
9.When cutting at an angle ensure that the rip fence is located on the right hand side of the blade.
10.When cutting rod, use a jig or fixture to prevent the workpiece from turning.
11.When cutting boards vertically, use a suitable push block to feed the workpiece into the saw.
12.Once finished turn off the laser light, turn off the tool by pressing the red 'OFF' button and unplug the tool from the power point to prevent unauthorised use.
Changing the batteries
1.Open the battery cover that is part of the laser light on/off switch.
2.Insert 2 x AA batteries taking care to insert the new batteries with the correct polarity.
WARNINGS. Use only correct batteries, 2 x “AA”.
DO NOT mix old and new batteries
DO NOT mix alkaline, standard
CAUTION. Remove the laser light batteries when the tool is to be stored without use for a few days or more. If left in
position, the batteries might leak and damage the laser light assembly. Damage due to leaking batteries is not covered under warranty.
14
