8.Use safety accessories. Safety glasses and earmuffs should always be worn. A face or dust mask is also required if the operation creates dust.
9.Do not abuse the power cord. Never pull the cord to disconnect the charger from the power point. Keep the cord away from heat, oil and sharp edges.
10.Do not overreach. Keep your footing secure and balanced at all times.
11.Look after your tools. Keep tools sharp and clean for better and safer performance. Follow the instructions regarding lubrication and accessory changes. Inspect tool cords periodically and, if damaged, have them repaired by an authorised service facility. Inspect extension cords periodically and replace them if damaged. Keep tool handles dry, clean and free from oil and grease.
12.Disconnect idle tools. Switch off the power and disconnect the plug from the power point before servicing, when changing accessories such as blades, bits and cutters, and when the tool is not in use.
13.Remove adjusting keys and wrenches. Check to see that keys and adjusting wrenches are removed from the tool before switching on.
14.Avoid unintentional starting. Always check that the switch is in the OFF position before plugging in the tool to the power supply. Do not carry a plugged in tool with your finger on the switch.
15.Stay alert. Watch what you are doing. Use common sense. Do not operate a power tool when you are tired.
16.Check for damaged parts. Before using a tool, check that there are no damaged parts. If a part is slightly damaged, carefully determine if it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, proper mounting and any other conditions that may affect the operation of the tool. A part that is damaged should be properly repaired or
replaced by an authorised service facility, unless otherwise indicated in this Instruction Manual. Defective switches must be replaced by an authorised service facility. Do not use a tool if the switch does not turn the tool on and off correctly.
17.Guard against electric shock. Prevent body contact with grounded objects such as water pipes, radiators, cookers and refrigerator enclosures.
18.Use only approved parts. When servicing, use only identical replacement parts. Use an authorised service facility to fit replacement parts.
29.Warning. The use of any accessory or attachment other than those recommended in this instruction manual may present a risk of personal injury.
20.Have your tool repaired by a qualified person. This electric tool is in accordance with the relevant safety requirements. Repair should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user.
Additional safety rules for band saws
•Ensure that the lighting is adequate.
•Keep the area free of tripping hazards.
•Do not let anyone under 18 years operate this saw.
•Always stand to one side when operating the saw.
•Never use a cracked or distorted saw blade. Only use sharp blades.
•When cutting round wood, use clamps that prevent the work piece from turning on the table.
•Never use your hands to remove sawdust, chips or waste close by the saw blade.
•Use only blades as recommended.
•Rags, cloths, cord, string and the like should never be left around the work area.
•Avoid cutting nails. Inspect the workpiece and remove all nails and other foreign objects before beginning sawing.
5
