Maintenance
This product has been designed to be a
1.ALWAYS handle the tool with care. Treat it as you would any optical device, such as a camera or binoculars.
2.AVOID exposing the self leveling vertical line generator to shock, continuous vibration or extreme hot or cold temperatures.
3.ALWAYS store the self leveling vertical line generator indoors. When not in use, ALWAYS store the self leveling vertical line generator in its protective case.
4.When you are finished using the tool, ALWAYS make sure that the switch is in “0” position.
5.ALWAYS keep the product free of dust and liquids. Use a damp cloth and mild soap to clean the tool. If needed, ONLY USE a soft cloth or cotton swab and glass cleaner to clean the lens.
WARNING: ALWAYS remove the batteries when cleaning lens.
6.ALWAYS clean and thoroughly dry the tool after each use.
7.Check the batteries regularly to avoid deterioration. ALWAYS remove the batteries from the tool, if it is not going to be used for an extended period of time.
8.Replace the batteries after approximately 40 hours of use.
9.DO NOT disassemble the self leveling vertical line generator.. This will not only void the warranty, but could expose the user to hazardous radiation exposure.
10.DO NOT modify the tool in any way or use the tool with
products and/or accessories not specified in this instruction manual, this could expose the user to hazardous laser radiation exposure.
11.DO NOT attempt to change any part of the laser lens.
NOTE: This tool is not to be tampered with and should only be repaired by a qualified Service Technician with laser experience.
Troubleshooting
Problem | Possible cause | Solution |
|
|
|
Laser line | Batteries are weak. | Replace with fresh batteries. |
projection is |
|
|
weak. |
|
|
|
|
|
Laser line is | Light in area is too | Use laser enhancing glasses. |
hard to see | bright. |
|
|
|
|
| Batteries are weak. | Replace with fresh batteries. |
|
|
|
Laser light is | Power switch is not | Check to be sure the power |
not projected. | “on” | switch has been pushed |
|
| forward and is in the “1” |
|
| position. |
|
|
|
Laser line | The tool is not placed | Replace the tool on a |
projected is | on a horizontal surface | horizontal surface and make |
not upright. | or the declining angle | sure the laser line can sway |
| of it is beyond ±3°. | after the tool is turned on. |
|
|
|
14 | 15 |
