In all three methods it is necessary to add the dust cover (19) in the hole in the base plate under the spindle and to lock it in place with the locking latch (22).
NOTE. With the dust cover in place it is not possible to use a router bit with a cutting diameter greater than 27.4mm (1”).
Using the template guide
The template guide can be used in various ways:
•Producing duplicates of a particular design of an original shape.
•In conjunction with a template, producing decorative features.
•Repetitive cutting shapes.
If you wish to make your own templates it is best to use a hardwood such as plywood. Use a piece that is just thicker than the depth of the template guide. Allow for the thickness of the guide in your template to ensure that the work piece is cut to the correct size.
Switching on and off
CAUTION. Before plugging in the tool always check that the trigger switch engages and disengages properly.
1. | First set up the work so you are ready to cut your wood. |
| |
2. | Plug the router into the mains socket. |
| |
3. | Press the on/off trigger switch (9) to turn on the router. |
| |
4. To switch off, just release the the On/Off switch (9). |
| ||
5. If you require the router to run |
|
| |
| 5 | ||
| continually without having to continue | ||
|
| ||
| to apply pressure to the trigger |
| |
| switch, depress the |
| |
(10) to lock the trigger switch on.
6.The router will now run in the
7.If the switch is in the
switch and then release the switch the router will stop.
Making a cut
Your router can be used to make specialty cuts and shapes in the surface and on the edge of wood. It accepts a wide range of bits that are each designed for a specific cut or shape.
Make all your adjustments as described in the previous sections. 1. Insert and secure your router bit.
1 | 2 |
1.To attach the template guide (16) turn the router upside down and remove the two fixing screws in the centre of the router base.
2.Insert the template guide into the base of the router and secure using the two fixing screws supplied.
Workpiece | Collet |
| |
Template | Template | ||
Nut | |||
| Guide | ||
|
| ||
| Router Base |
|
2.Adjust the height as required for the application.
3.Place the base plate (13) on the work piece ensuring that the bit is not in contact with the material to be cut.
11
4. Connect the router to the power supply.
