UV
bottom exposed (fig U). After locating centrally, lift the spark guard FULLY, ensuring the two parts rotate correctly and do not detach. With the guard in the FULLY upright position, there is only one threaded hole exposed. Replace the spark shield locking screw fully in this hole (fig V). Operate the spark guard up and down to ensure it is correctly located prior to turning the cut off saw on.
NOTE. Ensure that the depth
stop is adjusted to the correct W height before commencing operation. The adjustable
depth stop is threaded into the base of the machine at the rear. By raising and lowering the depth stop bolt with the 5mm hex key (fig W) the
travel of the cut off wheel can be controlled. This feature is particularly useful to prevent contact with the work bench surface when a new disc is fitted or increase disc travel as the abrasive disc wears. The depth stop should be checked and adjusted everytime a new disc is fitted.
Operation | X | |
1. Make all adjustments including | ||
| ||
setting the vice, fence position |
| |
and fence angle. |
| |
2. Ensure that the workpiece is |
| |
fully secured before starting |
| |
any cutting. |
|
NOTE. Ensure you are wearing the appropriate safety gear
including eye protection and hearing protection.
3.Check that the disc, guard and tool are in good condition.
4.Plug the cordset into the mains socket.
5.Push the
6.Bring the disc down onto the workpiece and allow it to cut its way through the workpiece without undue force. (fig X)
7.Once the cut is finished, raise the arm to clear the disc from the workpiece, release the trigger and the cut off saw will stop. Please note that the disc will continue to turn for a few revolutions even though the saw is switched off. Keep your hands well away from the moving disc.
11
