Overview
The cut off saw is used for cutting steel such as pipe, box section, rectangular, angle iron and steel bars. The saw can cut at angles from 0° to 45° left and right, it features a three position fence that permits an extended cutting range. The quick release vice allows fast adjustment whilst the
Attaching the rubber feet
1. | Tilt the saw onto its side. | A | |
2. | Take the rubber feet and | ||
|
insert 1 rubber foot into the matching slots on the base of the saw (fig A).
3.Ensure the rubber feet are fully inserted into the slots.
4.Repeat for the other side
and place the chop saw back on its base.
Attaching the vice handle
1.Fit the vice handle onto the end of the vice (fig B).
2.Fit the spring washer over the hex screw followed by the flat washer.
3. | Place the hex screw inside | B |
| the vice handle and secure |
|
| the vice handle to the vice by |
|
| tightening the hex screw in a |
|
| clockwise direction (fig C). |
|
4. Fit the cap onto the vice |
| |
| handle (fig D). |
|
| C | D |
Attaching the rear spark shield
1. Place the spring washer over | E |
the hex bolt followed by the | |
flat washer (fig E) and then |
|
fit the hex bolt through the |
|
spark deflector. Place the |
|
spark shield in the correct |
|
position (fig F) and tighten |
|
the hex bolt. |
|
2. Tighten the hex bolt to secure |
|
the spark shield in position | F |
(fig G). |
G
8
