Nikon P7700 manual Troubleshooting, Power, Display, Settings Issues, Problem Cause/Solution

Troubleshooting

If the camera fails to function as expected, check the list of common problems below before consulting your retailer or Nikon-authorized service representative. Refer to the page numbers in the right-most column for more information.

•See “Error Messages” (E95) for more information.

Power, Display, Settings Issues

	Problem		Cause/Solution	A
		•	Wait for recording to end.	–
		•	If the problem persists, turn the camera off. If the camera does	23
	The camera is on		not turn off, remove and reinsert the battery or batteries or, if
			you are using an AC adapter, disconnect and reconnect the AC
	but does not
			adapter.
	respond.
			Note that although any data currently being recorded will be
			lost, data that have already been recorded will not be affected
			by removing or disconnecting the power source.
		•	Battery is exhausted.	22
		•	Camera cannot be turned on if the battery-chamber/memory	18
		•	card slot cover is open.
			When the monitor is closed with the screen facing inward, the	8
	Camera cannot be		power cannot be turned on even if the power switch or c
			button is pressed.
	turned on.
			When a computer or printer is connected to the camera, the
Technical
			camera automatically turns on even if the monitor is closed. If
			you turn off the camera and turn it on again while it is
			connected to the computer or printer, open the monitor and
Notes			press the power switch.
		•	Battery is exhausted.	22
and		•	If no operations are performed for a while, camera has turned	23
	Camera turns off		off automatically by auto off to save power.
Index		•	Inside of the camera has become hot. Leave the camera off	–
	without warning.
			until the inside of the camera has cooled.
		•
			At low temperatures, the camera and the battery may not	F10
			function normally.
		•	Camera is off.	23
		•	Battery is exhausted.	22
	The monitor is	•	Standby mode for saving power: Press the power switch,	23
		•	shutter-release button or cbutton, or rotate the mode dial.	96, 99
	blank.		Camera and computer are connected via USB cable.
		•	Camera and TV are connected via audio/video cable or HDMI	96, E19
		•	cable.	E45
			Interval timer shooting in progress.
	Monitor screen is	•	Adjust monitor screen brightness.	110, E71
	hard to see.	•	Monitor is dirty. Clean monitor screen.	F13

F2