Nikon COOLPIXP7700BLK manual Error Messages, E95, Display Cause/Solution

Error Messages

The following table lists the error messages and other warnings displayed on the monitor, as well as the solutions for dealing with them.

Display	Cause/Solution	A
O	Clock not set.	E69
(flashes)	Set date and time.
Battery exhausted.	Battery exhausted.	16, 18
	Charge or replace the battery.
	Battery temperature is high.
	Turn off camera, and allow battery to cool down before
Battery temperature	resuming use. Five seconds after this message appears, the
	monitor is turned off, and the power-on lamp starts flashing	23
high
	quickly. After the lamps flash for three minutes, the camera turns
	off automatically, but you can also press the power switch to
	turn it off manually.
The camera will turn	Inside of the camera has become hot. The camera turns off
	automatically.
off to prevent		–
	Leave the camera off until the inside of the camera has cooled
overheating.
	and then turn it on again.
Q	Camera cannot focus.
	• Refocus.	30
(flashes red)			Reference
	complete.	–
camera to finish
	• Use focus lock.	86
Please wait for the	Camera cannot perform other operations until recording is
recording.	Wait until message clears from display automatically when		Section
	recording is complete.
Memory card is write	Write-protect switch of the memory card is in “lock” position.	–
protected.	Slide the write-protect switch to “write” position.
	Write-protect switch of Eye-Fi card is in “lock” position.	–
	Slide the write-protect switch to “write” position.
Not available if Eye-Fi
	Error accessing Eye-Fi card.
card is locked.
	• Check that the terminal is clean.	20
	• Confirm that memory card is correctly inserted.	20
This card cannot be	Error accessing memory card.
used.	• Use an approved card.	21
This card cannot be	• Check that the terminal is clean.	20
read.	• Confirm that memory card is correctly inserted.	20

E95