Global Machinery Company MXR56 Installing a saw blade, Switching on and off, Varying the speed

Installing a saw blade

CAUTION. Always ensure that the saw is switched off and unplugged from the mains supply before installing or removing a blade.

1.Open the blade clamp (4) by rotating it in an anti- clockwise direction. This will retract the pin and allow the saw blade to be inserted.

2.Whilst holding the blade clamp assembly open, line up and insert the new saw blade. Let go of the blade clamp assembly to lock the saw blade in position.

3.Pull on the blade to ensure it is securely fastened.

WARNING. Make sure that the blade is securely fastened before starting the saw. Failure to do so may result in serious injury.

Switching on and off

1.Connect the plug to the mains supply.

2.To start the saw, press the lock-off button (3) and squeeze the trigger switch (1).

3.There is no need to keep the lock-off button depressed once the saw has started. However, if the trigger switch is released, the lock-off button will re-engage as a safety precaution to prevent

accidental operation. In order to restart the saw, the both the lock-off button and the trigger switch must be pressed again.

Varying the speed

Vary the speed to suit the blade and the material being cut with the use of the speed control knob (2).

Changing the position of the shoe

WARNING. Always ensure that the saw is switched off and unplugged from the mains supply before making any adjustments.

1.Loosen the two shoe adjustment screws

(8) with a hex key (9) and position the shoe (5) to shield the length of saw blade as required.

2.Re-tighten the shoe adjustment screws (8). Take care not to overtighten the screws or you will strip the thread.

3.Position the angle of the shoe as required by pivoting it on its axis (6).

CAUTION. Do not operate the reciprocating saw if the adjustable shoe is not installed.

8