4.Have a second person hold the Upright (6) near the Frame (2) as shown.
Pull the Wire Harness (48) out of the Frame (2) and insert it upward through the Upright (6). Do not let the Wire Harness fall into the Upright; use a piece of tape or an elastic band to hold the Wire Harness in place until step 12.
Insert the Upright (6) into the Frame (2). Attach the Upright with three M8 x 16mm Patch Screws (95) and three Star Washers (92). Avoid pinch- ing the Wire Harness (48) between the Upright and the Frame.
5.Identify the Left Roller Leg (12), which is marked with a “Left” sticker. Orient the Left Roller Leg as shown near the left Crank Arm (36).
Apply a small amount of the included grease to both sides of a Wave Washer (98). Also, apply grease to the Roller (22) on the Left Roller Leg (12); spread the grease evenly around the Roller.
Slide the Wave Washer (98) onto the left Crank Arm (36). Next, slide the Left Roller Leg (12) onto the Crank Arm and set the Roller (22) on the Base (1). Attach the Left Roller Leg with an M10 x 20mm Patch Screw (91), a Crank Axle Cap (30), and an M10 x 25mm Washer (94).
Repeat this step to attach the Right Roller Leg (21) to the right Crank Arm (not shown).
4 |
|
| 48 |
| 6 |
| 95 |
| 92 |
95 |
|
| 2 |
| 92 |
| 95 |
5 | 36 |
| |
Grease | 98 |
| |
94 |
|
30 |
|
| 21 |
91 |
|
12 |
|
| 1 |
| 22 |
| Grease |
7
