1.
To make assembly easier, read the informa- tion on page 5 before you begin assembling the elliptical exerciser.
Identify the Rear Stabilizer (4). While another person lifts the rear of the Frame (1), attach the Rear Stabilizer to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (29).
2.See the inset drawing. Remove the two M10 x 45mm Button Bolts (33) and the packing tubes from the front of the Frame (1). Remove the rubber band from the Lower Wire Harness (87). Discard the rubber band and the packing tubes.
Attach a Wheel (32) to the Front Stabilizer (3) with one of the M10 x 45mm Button Bolts (33) you just removed and an M10 Nylon Locknut (29). Do not overtighten the Nylon Locknut; the Wheel should turn freely.
Attach the other Wheel (32) to the Front Stabilizer (3) in the same way.
3.Slide an M10 Split Washer (94) onto each of the two M10 x 83mm Button Screws (63). Insert the Button Screws into the Front Stabilizer (3). Next, slide the Mast (15) onto the Button Screws and against the Front Stabilizer. Make sure that the Mast is oriented as shown.
While another person holds the Mast (15) and the Front Stabilizer (3) near the Frame (1), connect the Extension Wire Harness (95) to the Lower Wire Harness (87). Insert the connectors on the Wire Harnesses into the Mast.
While the other person lifts the front of the Frame (1), carefully pull the upper end of the Extension Wire Harness (95) to remove any slack. While holding the upper end of the Extension Wire Harness, attach the Mast (15) and the Front Stabilizer (3) to the Frame with the two M10 x 83mm Button Screws (63).
Do not tighten the Button Screws yet.
Make sure that the Wire Harnesses (87, 95) do not get pinched and damaged during this step.
1 |
|
|
|
|
|
| 29 |
|
|
| 1 |
|
| 29 |
|
|
|
| 4 |
|
|
| 34 |
2 | Packing |
|
|
|
|
| |
| Tube |
|
|
| 33 | 87 |
|
|
|
| |
Packing Tube | 1 |
| |
|
|
| |
|
| 32 | 3 |
|
| 29 |
|
| 32 |
|
|
| 33 |
|
|
3 | Pull |
|
|
|
|
| |
|
| Make sure that the | |
|
| wire harnesses do | |
|
| not get pinched | |
|
| and damaged | |
|
| during this step | |
| 15 |
|
|
| 3 | 95 |
|
| 63 |
|
|
| 94 |
|
|
|
| 87 |
|
|
|
| 1 |
6
