Gold's Gym GGTL03607.2 manual Make sure that the power cord is unplugged

1.	Make sure that the power cord is unplugged.	1
	With the help of a second person, carefully tip
	the treadmill onto its left side. Partially fold the	Tie		77		Hole
	Frame (48) so that the treadmill is more stable;
	do not fully fold the Frame yet.					81
	Cut the tie securing the Upright Wire (77) to the
	Base (85). Locate the tie in the indicated hole in	48					2
	the Base, and use the tie to pull the Upright Wire
	out of the hole.
	Attach a Base Pad (81) to the Base (85) in the					85
	location shown with a Base Pad Spacer (64) and
	an M4.2 x 25mm Screw (2). Then, attach an-	64	81
	other Base Pad (81) with only an M4.2 x 25mm			2
	Screw (2).
2. Attach a Wheel (86) to the Base (85) with an		2
	M10 x 50mm Bolt (27) and an M10 Nut (33). Do			Tie	77
	not overtighten the Nut; the Wheel must turn
	freely.
	Cut the tie off the Upright Wire (77).	27
			33	86	85
3. Identify the Right Upright (78) and the Right		3			Wire Tie
	Upright Spacer (80), which are marked with					78
	stickers. Insert the Upright Wire (77) through the
	Right Upright Spacer as shown.	77					77
	See the inset drawing. Tie the wire tie in the
	Right Upright (78) securely around the end of						80
	the Upright Wire (77). With the help of a second
	person, hold the Right Upright near the Base
	(85). Then, pull the other end of the wire tie until
	the Upright Wire is routed completely through
	the Right Upright.					85
			78
		77	Wire
			Tie
		7