Gold's Gym GGTL03607.2 manual Careful not to pinch the Upright Wire, Not fully fold the Frame yet

4. Hold a Bolt Spacer (79) inside the lower end of	4
the Right Upright (78). Insert an M10 x 96mm					5
Bolt (5) with an M10 Star Washer (8) into the
Right Upright and the Bolt Spacer. Repeat this			78
step with a second Bolt Spacer (79), M10 x
96mm Bolt (5), and M10 Star Washer (8).						877		79
Hold the Right Upright Spacer (80) and the
Right Upright (78) against the Base (85). Be
careful not to pinch the Upright Wire (77).
Tighten the M10 x 96mm Bolts (5) with your fin-						80	79	82
gers; do not fully tighten the Bolts yet.
Press a Base Endcap (82) into the Base (85).						85
5. With the help of a second person, carefully tip	5
the treadmill onto its right side. Partially fold the
Frame (48) so the treadmill is more stable; do
not fully fold the Frame yet.	81					48
Attach a Base Pad (81) to the Base (85) in the
location shown with a Base Pad Spacer (64)	2						27
and an M4.2 x 25mm Screw (2). Then, attach
another Base Pad (81) with only an M4.2 x	85			64
25mm Screw (2).
Attach a Wheel (86) to the Base (85) with an						86
M10 x 50mm Bolt (27) and an M10 Nut (33). Do				2	81
not overtighten the Nut; the Wheel must turn							33
freely.
6. With the help of a second person, hold a Bolt	6
Spacer (79) inside the lower end of the Left
Upright (73). Insert an M10 x 96mm Bolt (5) with			5			73
an M10 Star Washer (8) into the Left Upright
and the Bolt Spacer. Repeat this step with a			8	83
second Bolt Spacer (79), M10 x 96mm Bolt
(5), and M10 Star Washer (8).
Orient the Left Upright (73) and the Left Upright
Spacer (83) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base	82	79
(85). Tighten the M10 x 96mm Bolts (5) with			85
your fingers; do not fully tighten the Bolts yet.
Press a Base Endcap (82) into the Base (85).
With the help of a second person, tip the tread-
mill so that the Base (85) is flat on the floor.
	8