MICRO1468I.book Page 7
Getting started
Using the support stand
If the unit is to be operated on a desk or table, extend the support stand (located on the underside of the unit). If the unit is to be wall mounted, return the support stand to the closed
position.
01
Connecting to power
Before switching on make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. For your own safety read the following instructions carefully before attempting to connect this unit to the mains.
The remote control battery
To preserve the battery life prior to first use, there is a small plastic tab inserted between the battery and the terminal inside the remote control. Please remove this tab before using the remote control. To remove the tab, pull it in the direction of the arrow in the illustration below.
If the operation of the remote control becomes intermittent or unsatisfactory, replace the original battery with a new
DON’T FORGET!When replacing the battery, always ensure the same size and type is used. Make sure that the battery polarity is observed. Inserting the battery incorrectly could result in battery leakage or damage to the unit.
Mains (AC) operation
This unit is designed to operate on AC
Connect the mains adaptor to the DC input socket (18) on the rear of the unit
DON’T FORGET!Use only the mains adaptor supplied with this Micro System. Using adaptors not designed for this unit, or that have a different specification to the one supplied, may cause damage to the unit.
7
