9
INSTALLATION
OPERATION

Remote Control

1. Remove the battery cover at the rear of the remote control unit and insert 2
pcs “AAA” size batteries (not included) into the battery compartment with the
correct polarity.
2. Place back the cover and close the battery compartment.
1. Connect the power adapter between wall jack and transmitter. The LED will
turn to Green.
2. Turn on the audio source (TV or audio component) to which the transmitter is
connected with. The LED will turn from Green to Blue.
3. Select the channel 1, 2 or 3 of the transmitter for best performance in your
location.
4. Turn on the Power button on the speaker and adjust the volume by pressing
“+” and “-“ for desired listening level. Volume can also be adjusted by
pressing “+” and “-” button located on the remote control unit.
5. Push the “AUTO TUNE” button to get the best tuning reception in the
speakers. When the button is pressed, frequency tuning starts automatically
and it stops when a signal is detected.
5. You should now be able to place the speakers freely inside or out within 150
feet from the transmitter.