Wacom 12WX, DTZ-1200W manual Display Installation

STEP 1: DISPLAY INSTALLATION

In this step, Cintiq is installed as a display on your system.

Important: Do not connect the USB data cable until instructed to do so.

•Turn off your computer.

Caution: Never connect or disconnect the video or power cables while your computer or Cintiq are powered on – this can damage the display or video card.

•If your computer has only one video connector, you will need to unplug your previous display. Determine if your computer has a digital (DVI) or analog (VGA) connector, and set the DVI/VGA switch located on the converter unit for the video connection you are using. See – A – in the connection diagram on page 13.

•Making sure to tighten the thumbscrews on the connectors, follow the instructions below for your video connector. See – B –

DVI-I connector

DVI-D connector

For DVI operation, connect the Cintiq video cable between the DVI-I connector located on the converter unit and the DVI-D or DVI-I connector on your video card. Be sure to connect the DVI-I end of the cable to the converter box, and the DVI-D end to your video card.

		For VGA operation, connect the Cintiq video cable between the DVI-I
		connector located on the converter unit and the VGA connector on your video
		card.
VGA connector
		If connecting to an Apple ADC or mini-VGA connection, you will need to obtain
		an appropriate adapter. Adapters can be purchased at various retail outlets.
		For ADC operation, plug the DVI-D end of the Cintiq video cable into the ADC
	Apple ADC	to DVI-D adapter. Then connect the DVI-I end of the Cintiq cable to the DVI-I
	connector	connector on the converter unit. Next connect the ADC adapter end to the
		ADC connector on your video card.

For an Apple mini-VGA connector, plug the VGA end of the Cintiq video cable

into the mini-VGA port adapter. Then connect the DVI-I end of the Cintiq cable

Mini-VGA port to the DVI-I connector on the converter unit. Next connect the mini-VGA port end to the mini-VGA port on your video card.

•Plug the pen display’s integrated cable into the matching connector on the converter unit. When fully seated, the connector will snap into place. See – C – on the next page.

•Connect the power adapter to the converter unit. Then connect the adapter’s power cable and plug the adapter into an AC outlet. See – D – and – E –

•Turn on Cintiq. The power LED will light orange.

Installation

Page 12