Setup
Left Side
Shown
(45°)
Open Port
FIG. 21: Orientation of Venting Fittings
5.Install plug (6) in opposite port and torque to
NOTE: Occasionally inspect the inside of the hopper for any leakage of outer cavity heating fluid.
Fill Spray Material
Condition materials prior to adding to hoppers. Ensure resin materials are thoroughly agitated, homogenous, and pourable prior to adding to hopper. Stir hardeners back into suspension prior to adding material to hopper.
1.Disconnect spring strap (7) from front post and remove lid (1c). Keep connected to lanyard (10).
10
7
1c 
FIG. 22: Remove Lid
2.Pour desired amount of spray material through strainer inside hopper (D). See Table 1: Fluid Capacities of 20 Gal. Hopper.
D
FIG. 23: Fill Spray Material
3.Tightly secure lid (1c) on hopper (D) and reconnect spring strap (7).
16 | 312747L |
