
Overview
The left side of the mix manifold is intended for the major volume material, or the higher viscosity material if using a 1:1 volume mix. This side is referred to throughout the manual as the resin side or “A” side. The right side is referred to as the hardener side or “B” side.
See FIG. 2 to view flow of A and B material inside the XM PFP Mix Manifold.
The resin and hardener enter the manifold through the manifold inlet ports. The A material flows through the manifold to the material outlet port. The injector tube creates a hollow stream of A material for the B material to combine with once the hardener exits the injector (P). The resin and hardener materials enter the mix manifold outlet (R) before the materials enter the first length of integrator fluid hose (L). The materials then pass through the mixer assembly (S) where they are thor- oughly mixed. Then they pass through a length of mix hose (T1) where the continue to be lightly mixed before entering the fluid whip hose (T2) then the gun (U).
Top View
Overview
Follow these recommendations for setup (see FIG. 1 on page 6):
•Use at least a 1/2 in. (12 mm) x 2 ft (0.6 m) integra- tor hose (L) connected to the mix manifold outlet
•Use at least 12 elements in the static mixer after the integration hose and before the mix hose (T1).
•Use at least a 1/2 in. (12 mm) x 10 ft (3.0 m) mix hose (T1) after the static mixer and before the spray gun.
Front View | 45 |
A | B | ti20091a |
SECTION |
| |
SECTION |
| UBKGUZ |
|
|
Hardener
Resin
Combined Material
FIG. 2: Cutaway View
3A2988B | 7 |