Graco 2770 Setting Up the Baby Monitor, Testing the System, Solutions aux problèmes, Aucun son

Setting Up the Baby Monitor

1.Check that both Nursery Unit and Parent’s Unit are set to the same channel.

2.Place the Nursery Unit within 10 feet (2-3 meters) of your baby. Plug an AC adapter into the jack on the side of the Nursery Unit. Plug it into a working 120 volt AC outlet.

3.Aim the Nursery Unit toward your baby. Check that there are no walls or large objects that could block sound transmission.

4.Turn on the Nursery Unit using the ON/OFF switch. The green power light should come on.

5.Install a 9 volt battery into the Parent’s Unit, or plug it into a working 120 volt AC outlet using the other AC adapter.

6.Turn on the Parent’s Unit using the volume control dial. The green power light should come on.

Testing the System

It is VERY IMPORTANT to test the system when first set up, and at regular times thereafter. Test the units any time they may have been damaged or have not been used for a long time.

1.If two adults are present, have one take the Parent’s Unit to different locations, trying various volume settings, while the other speaks into the Nursery Unit.

2.If only one adult is available, place a ticking clock, radio, or other sound-producing device near the Nursery Unit to test it.

3.When testing, keep the level of your child’s sounds in mind, and adjust the volume accordingly.

4.If there is sound interference, switch both the Nursery Unit and the Parent’s Unit to the other channel setting.

NOTE: As with all radio frequency devices, transmission range and reception may vary. Your Nursery Monitor uses public airwaves, so it is possible for conversations near the Nursery Unit to be broadcast to other nursery monitors, radios, cordless phones or scanners outside your home. For your privacy, always turn off the Nursery Unit when not in use.

This monitor operates on one or more of the following frequencies: 925.7-927.5 Mhz and 902.5-904.3 Mhz.

Solutions aux problèmes

N’ESSAYEZ PAS DE MODIFIER L’UNITÉ.

Toutes modifications à l’émetteur ou au récepteur invalidera

l'autorité du consommateur à utiliser l’appareil.

Pour la plupart des problèmes, il y a une simple solution. Vérifiez d’abord que:

•Chaque unité est en position de marche

•Chaque unité est branchée (ou que l’unité des parents soit munie d’une bonne pile)

•La prise de courant est active

•Les unités sont à la même fréquence

•Le bouton du contrôle de volume est monté sur l’unité des parents

•L’unité des parents est dans le rayon de portée de l’unité de la nursery

Aucun son

•Pile épuisée ou faible — remplacez ou utilisez l'adaptateur CA.

•Les choix de la fréquence ne correspondent pas — placez les deux unités à la même fréquence.

•L'adaptateur CA est mal branché — vérifiez les connections.

•L’unité de la nursery est recouverte ou obstruée — retirez l'obstruction.

FRANÇAIS

903-5-01 8 17 903-5-01