Grounding
Before operating the pump, ground the system as explained below. Read the warnings on page 4.
Ground all of this equipment:
•Pump: use a ground wire and clamp. See FIG. 3. Loosen the grounding screw (X). Insert one end of a 12 ga (1.5 mm2) minimum ground wire (Y) under the clamp and tighten the screw securely. Connect the other end of the wire to a true earth ground. For a ground wire and clamp, order Part No. 222011.
•Air and fluid hoses: Use only electrically conductive hoses.
•Air compressor: Follow manufacturer’s recommen- dations.
•Fluid supply drum: Follow your local code.
Installation
•All fluid pails used when flushing: Follow your local code. Use only conductive metal pails placed on a grounded surface. Do not place the pail on a non- conductive surface, such as paper or cardboard, which interrupts the grounding continuity.
X
Y
TI2126A
FIG. 3. Grounding the Pump
311688L | 9 |
