Graco 312759R - page 23

Setup

312759R 23

Overview

There are five Edit screens. Edit Screen #1 is the Shot

Editing screen and Edit Screens #2-#5 are Sequence

Editing screens. Edit Screen #1 shows Shot #1 through

Shot #50. Each shot has a defined shot size that is mea-

sured in grams.

Edit Screens #2-#5 show Sequence A through

Sequence G. Each sequence has ten positions; shown

as A0 to A9 in FIG. 10. Each of the ten positions in the

sequence uses one of the Shot Numbers (GD) defined

in Edit Screen #1. The third column in FIG. 10 shows the

shot sizes (GE) for the selected Shot Numbers.

When operating in Sequence mode and a shot in the

sequence is finished, the machine will automatically

select the next position in the sequence that uses a Shot

Number with a non-zero shot size.

When operating in Sequence mode, there is an option to

allow the machine to automatically perform all of the

shots in the sequence with a preset delay between

shots. The delay between Shots(GF) is shown in the

fourth column. This process is called Auto-Sequencing.

Edit Shot Size

To edit the defined shot size(GE) for a certain shot

number using Edit Screen #1, use the following proce-

dure.

1. Navigate to the Edit Screen #1. See Screen Navi-

gation Diagram, page 16.

2. Press the Enter/Exit Screen button (GA) to enter the

screen.

3. Use the arrow keys to navigate to the shot size for

the Shot Number to be changed.

4. Use the numeric keypad to enter the desired shot

size in grams.

5. Press the Enter button ( ) to accept the shot

size and exit editing mode.

6. Press the Enter/Exit Screen button (GA) to exit the

screen.

Edit Shot Sequence

To change which Shot Numbers (GD) from Edit Screen

#1 are used in a sequence, use the following procedure.

1. Navigate to the Edit Screen that contains the

Sequence to be changed. See the list below, then

see Screen Navigation Diagram, page 16.

• Sequences A and B are on Edit Screen #2

• Sequences C and D are on Edit Screen #3

• Sequences E and F are on Edit Screen #4

• Sequence G is on Edit Screen #5

2. Press the Enter/Exit Screen button(GA) to enter the

screen.

3. Each Sequence Position(GC) uses a Shot

Number (GD). Use the arrow keys to navigate to the

Shot Number for the sequence position to be

changed.

4. Press the Enter button ( ) to enter editing

mode.

5. Use the Up Arrow button ( ) or the Down Arrow

button ( ) to change the Shot Number.

6. Press the Enter button ( ) to accept the Shot

Number and exit editing mode.

FIG. 11: Edit Shot Number in Sequence

Only Shot Numbers with non-zero shot sizes will be

available for selection.

GC GD