|
| Troubleshooting |
| Troubleshooting |
|
|
|
|
Problem | Cause | Solution |
|
|
|
|
|
|
Engine will not start | Engine switch is OFF | Turn engine switch ON |
| Engine is out of gasoline | Refill gas tank. Honda Engines |
|
| Owner's Manual. |
|
|
|
| Engine oil level is low | Try to start engine. Replenish oil, if |
|
| necessary. Honda Engines Owner's |
|
| Manual. |
|
|
|
| Spark plug is disconnected of dam- | Connect spark plug cable or replace |
| aged | spark plug |
|
|
|
| Cold engine | Use choke |
| Fuel shutoff lever is OFF | Move lever to ON position |
| Oil is seeping into combustion | Remove spark plug. Pull starter 3 to 4 |
| chamber | times. Clean or replace spark plug. |
|
| Start engine. Keep sprayer upright to |
|
| avoid oil seepage |
|
|
|
Engine operates, but displacement | Pump switch is OFF | Turn pump switch ON |
pump does not operate |
|
|
Pressure setting too low | Turn pressure adjusting knob clock- | |
|
| wise to increase pressure. |
|
|
|
| Fluid filter (29) is dirty | Clean filter. Page 22. |
| Tip or tip filter is clogged | Clean tip or tip filter. Manual 309639. |
| Displacement pump piston rod is | Repair pump. Manual 309250. |
| stuck due to dried paint |
|
|
|
|
| Connecting rod is worn or damaged | Replace connecting rod. Page 8. |
| Drive housing is worn or damaged | Replace drive housing. Page 8. |
| Electrical power is not energizing | Check wiring connections. Page 11. |
| clutch field | Reference pressure control repair. Page 13. |
|
| |
|
| Reference wiring diagram. Page 23. |
|
| With pump switch ON and pressure turned to |
|
| MAXIMUM, use a test light to check for power |
|
| between clutch test points on control board. |
|
| Remove clutch wires from control |
|
| board and measure resistance across |
|
| clutch coil. At 70° F, the resistance |
|
| must be between 1.2 +0.2Ω; if not, |
|
| replace pinion housing. |
|
| Have pressure control checked by authorized |
|
| Graco dealer |
|
|
|
| Clutch is worn, damaged, or incor- | Adjust or replace clutch. Page 9. |
| rectly positioned |
|
|
|
|
| Pinion assembly is worn or damaged | Repair or replace pinion assembly. Page 9. |
6 | 310813 Rev C |
