Graco 3A0096B Setup, Tighten Clamps, Wet Cup Drain Fitting, Torque Wet Cup

Setup

Setup

Tighten Clamps

See FIG. 4. Before starting, torque the screws (3) secur- ing the four clamps (4) to 21-25 ft-lb (28-34 N•m).

1 Torque to 21-25 ft-lb (28-34 N•m).

Wet Cup Drain Fitting

As supplied, the side port of the wet cup is plugged. To install a drain tube, remove the plug and install the sup- plied 90° tube fitting (R) in its place. Attach a 1/2 in. (13

mm)ID flexible plastic tube (not supplied) to the fitting to drain any overflow to a pail.

3 1

ti14668a

FIG. 4. Wet Cup

Wet Cup

See FIG. 5. Before starting, fill the wet cup (P) 1/3 full with Graco Throat Seal Liquid (TSL) or compatible sol- vent.

NOTE: The wet cup has a covered fill port fitting. A plug

(9)is shipped loose with the pump and can be installed in place of the covered fitting if desired.

Torque Wet Cup

MaxLife pumps use a special u-cup throat seal that is non-adjustable and does not require periodic torquing.

P

R

9

ti14667a

FIG. 5. Wet Cup

12 3A0096B