Operation
Adjust the Spray Pattern
NOTE: Use this procedure with
1.See FIG. 4. Close off pattern adjustment air by turn- ing knob (AA) clockwise (in) all the way. This sets gun for its widest pattern.
AA
OUT (narrower | AA |
pattern) |
|
IN (wider pattern)
ti6559A
FIG. 4. Pattern Air Knob
2.See FIG. 5. Set atomizing air pressure at about 5 psi (0.35 bar, 35 kPa) when triggered. Check spray pat- tern, then slowly increase air pressure until tails are completely atomized and pulled into spray pattern.
Do not exceed 100 psi (0.7 MPa, 7 bar) air pressure to gun.
3.See FIG. 4. For narrower pattern, turn pattern adjustment valve knob (AA) counterclockwise (out). If pattern is still not narrow enough, increase air pressure to gun slightly or use different size tip.
no air | too little air | correct |
|
|
| amount of |
|
|
| air | TI0792A |
FIG. 5. Spray Pattern Problems
Shutdown
Follow Pressure Relief Procedure, page 10.
Always flush the pump before the fluid dries on the dis- placement rod. See Flush the Pump on page 13.
12 | 3A0732J |