High
side of
ring

To Assemble Your Convertible Entertainer® Activity Center

Step 1.

Position three stands under base as shown, and push down on base until stands snap in place.

Stands can fold flat under base to permit rocking.

Step 2.

With notch at bottom of

 

upper leg as shown, push

 

in the button on front of

 

each lower leg and insert

Notch

an upper leg section until it

PUSH

snaps into one of three

 

heights for infant use. Set all

 

three legs to same height.

 

Step 3.

Turn two halves of tray upside down. Put the end of tray with an “A” printed on it inside the end with a “B”. Fasten ends “A” and “B” to each other with four Phillips head screws. Do not overtighten screws.

Snap the other two ends of tray together so it forms a closed circle in the center of the tray.

Step 6.

Place folded Toddler Unit Conversion Instructions into clear plastic seat pocket.

Step 7.

Put cloth seat inside the seat ring as shown. Toddler Unit instructions must face high side of seat ring as shown.

Attach seat to the seat ring by wrapping top edge of seat around seat ring. Under the seat ring, snap the grommets

onto the pegs as shown.

Tuck the seam on both sides Grommet of the cloth seat between the outside of the ring and the

plastic partitions as shown.

Check that edge of cloth seat does not cover wheels or partitions.

Step 8.

Turn the seat over and push seat down into the seat ring.

Step 9.

Snap the seat ring onto the tray. Push down all around seat to make sure it is completely snapped onto the tray. Seat must turn freely.

Toddler Unit instructions

Seam behind

partition

Step 4.

Turn tray right side up. Push five large plastic bolts into the five holes as shown until they snap in place.

Step 5.

Place tray on top of legs so that snapped ends of tray are in front of the Graco® name on the base, and bolt in circle at back of tray goes into back leg on the base. Align other two bolts with holes in the legs. Fasten all three bolts. Check that bolts are secure by pulling up on tray.

651-3-00 651699

5

Bolt in

circle

Snapped

Back leg

ends in front

 

Step 10.

Refer to illustration below to attach toys to tray. Detailed assembly instructions follow.

6

Page 3
Image 3
Graco 4650 instruction sheet To Assemble Your Convertible Entertainer Activity Center, Step