Graco 4650 Shown. Push down firmly Until loop snaps in place, That both front and back, Place

1. Thread cord attached to		5. Align cup over largest hole
dog phone through the two		in tray so cup handle is next
holes found on each of the		to the house. Snap pins of
three people figures. Insert		cup into holes in tray.
end of cord into small hole
on tray as shown.
Tie a knot under the tray to
hold cord in place.
		6. Snap together the two
2. Push three rings past the		halves of ball holder as
		shown. Spread ends apart
bumps onto the ring loop,
	Bumps	and attach ball by inserting
and insert ends of ring loop
		two pins on ball holder into
into the two holes in tray as
		holes in ball.
shown. Push down firmly
until loop snaps in place.
		Holding ball/ball holder
		assembly together, push
		holder down into tray as
3. Remove and immediately		shown until it snaps in place.
discard the plastic pull tab
on the printed circuit board.
Attach three music buttons
over circuit board in music
lid. For each button, first put		7. Cut out the double-sided
front end of button into lid so
		pictures from included artwork,
tooth fits into slot in lid, then
		or use your own pictures.
push down back of button so
		Insert a picture into smaller
it snaps onto pegs. Check
		half of each clear plastic
that both front and back of
		page, then snap small and
each button are snapped
		large halves together.
in place.
Snap pegs of lid into holes		Insert one peg of each page
at both sides of the storage
compartment in tray.		into one of the three holes in
		tray as shown. Insert other
		peg into corresponding hole
		in plastic page retainer. Snap
4. Assemble the house. Put		retainer into slots in tray.
lower pivot pin of door into
hole in house base. Align		To open pages to replace
roof over base so upper pin
		pictures, insert a coin into
of door fits into hole at side
		the center slot and pry it
of doorway. Holding pieces
		open as shown.
together, turn assembly
upside down, locate the four
screw holes, and fasten with
four screws. Do not over-
tighten screws.
After house is assembled,
align house over round ends		8. Push end of butterfly
of tray halves so mirror faces
		wand firmly into remaining
center of tray. Insert base of
		hole on tray as shown until it
house into the four slots, and
		snaps in place.
turn clockwise until house is
latched to tray.

7 8