Step 6.
Pick up your baby and sit down, placing the baby’s bottom on the narrow crotch section of the carrier.
Baby’s arms
should be
between the
two tabs
Step 7.
Gently raise baby up against you, taking special care to support a young infant’s head.
Thread the bottom tabs through the bottom rings.
Make sure baby’s legs go through the openings under the buckles. Buckle them (listen for a click) and pull the straps snug.
Step 8.
Then thread the top tabs through the top rings. The end of the tab must be turned sideways as shown to fit it through the ring.
Baby’s arms must go through the opening, NOT over the top of the carrier.
Snap the tabs securely in the best position for your baby’s size.
Step 9.
Adjust baby’s pouch if needed by adjusting the strap under the crotch to raise or lower your baby.
Compare your fitted carrier to this picture, making sure that baby’s arms go through the top openings and legs go through the bottom openings. Check that all buckles and snaps are secure.
A very small baby may need extra head support. Thread the top tabs through the head support loops, then through the top rings as shown.
7 | 8 |
