To Fold Your Pack ’N Play®
Step 1.
Remove the canopy and lower the back flap. Apply locks on wheels. Release the two VELCRO® straps under the Pack ’N Play, and remove the mattress.
Step 2.
IMPORTANT: Raise center halfway BEFORE unlocking rails.
Grasp center loop as shown and pull up approximately halfway to the top rails.
Step 3.
The top rail has a center piece with two tubes hidden under the fabric. The button on the bottom of the center piece releases the two tubes when it is pushed up.
Center
piece
Tube
Push UP button
under fabric
To fold the top rail:
!Lift up slightly on the top rail.
!Push up on the button located under the symbol 
!to release the two tubes.
!Push down.
HINTS:
!If top rails do not unlatch, lift
! the center of the floor higher.
!Both tubes must be released
!for the top rail to fold.
Step 4.
Pull center up all the way.
Step 5.
Gather your unit together.
Do not force.
If unit will not fold, look for a partially latched top rail. Squeeze the latch button to release the rail.
Step 6.
Find the bottom corner belt loop (only one). This loop is for holding unit and mattress together while carrying.
Step 7.
Wrap the mattress around your unit. Position the mat- tress so the mattress handle is on the opposite side of the wheels. Fasten together the VELCRO® straps.
Fold the tubes and canopy, and fit the tubes and canopy snugly into the unit. It is not necessary to remove the tube from the canopy. Grasp the tube on either side of a joint and pull apart. Repeat at other joint. Fold the tube and canopy together.
10
T
Pl flo fa
Pu su at m
Pu ov un
Tu ba
