Installing Base Using Vehicle Seat Belt | Graco PD163434A manual

9.0 Installing Base Using Vehicle Seat Belt

You must carefully follow the instructions provided by your vehicle manufacturer, in addition to the information in this manual. Before proceeding be sure you have read and understood, “7.0 Choosing an Appropriate Vehicle Seat

Location” on pages 22-26.

Make sure vehicle is on level ground A and not like in picture B.

If a front passenger seat is used (see air bag warning, page 4), slide the vehicle seat rearward as far as possible from the dashboard. If a rear seat is used, make sure the seat in front of it is moved forward enough and is upright enough to allow room for the child restraint.

When using the vehicle seat belts to install the base, the lock-off is ALWAYS used to secure both belts of the lap or lap/shoulder belt.

1.Position base in vehicle seat as shown C.

2.Open the lock-off and route the vehicle belt through the belt path and over the lock-off D.

3.Buckle seat belt. Pull up on shoulder belt while pushing down on base to tighten E.

4.Close lock-off F.

5.Test base for secure installation by moving front to back and left to right at the belt path G. Base should not move more than 1 inch ( 2.54 cm). If belt loosens or lengthens, repeat procedure.

Lap Belt H and Lap/Shoulder Belt I should appear as shown when installed.

30

Image 30

Graco PD163434A owner manual Installing Base Using Vehicle Seat Belt

Contents

Smart SeatTM Child Restraint Table of Contents REAR-FACING Page Properly Routing the Vehicle Seat Belt or Latch Page Never Attach two Latch connectors Page Page Register Your Child Restraint Model Number Manufactured Purchase Date Child Restraint Useful Life For Recall Information If You Need HelpCertification Second Hand Child Restraint Attaching Latch Storage Compartment Attaching Cupholder Click Features Page Base Page Height & Weight Limits Preterm or Low Birthweight Infants Rear-facing with base 5 to 40 lbs .2-18.1 Kg Forward-facing with base 20 to 65 lbs to 29.5 kg Booster Without base 30 to 100 lbs .6 to 45 kg Vehicle Seat Location Requirements Serious Injury or DEATH. Some seating Vehicle Seat Belt Requirements Safe Vehicle Seat Belt Systems For Built-in Harness Only With or Without Built-in HarnessCombination Lap/Shoulder Belt with Combination Lap/Shoulder Belt with Retractor Unsafe Vehicle Belt SystemsLap Belts with Emergency Locking Retractor ELR Passive Restraint Lap or Shoulder Belt Mounted on Door Passive Restraint Lap Belt with Motorized Shoulder Belt What is LATCH? Latch Vehicle Lower Anchor Points Seat Crease Vehicle Top Tether Latch System REAR-FACINGFORWARD-FACING Installing Base Using Vehicle Seat Belt Vehicle BeltLap Belt Installing Base Using Latch Belt must lay flat and not be twistedPage REAR-FACING Installation Locked FORWARD-FACING Installation Tether Tether USE Tether Storage Latch Storage Buckle Harness StrapsChest Clip Crotch Strap Bottom Body Support on certain models To prevent ejection in sudden stop or crash Harness Covers & Crotch Strap Cover on certain models To prevent serious head injury in sudden stop or crash Using Recline FORWARD-FACING Safety Check Placing Child in Child Restraint Chest Clip Buckle Check Harness System To prevent serious injury or death Adjusting Head Support/ Harness Straps Refer to page 48 for harness strap Placement.49 Booster Installation D19.1 Storing Harness Bottom Using Child Restraint in Booster Mode Page Head Support in Booster Mode , p Securing Child in Booster Seat and Vehicle Armrest Shoulder Belt Lap belt Adjusting Head Support in Booster Mode Adjusting Armrest Additional Information Removing Seat Cover Care and Maintenance Airplane Use Warranty,and Replacement Parts