Graco PD204108A owner manual REAR-FACING Installation with Latch

REAR-FACING INSTALLATION WITH LATCH

1Adjust child restraint to recline position (fig. a). Flip recline feet under child restraint for rear facing use.

-AKE SURE &ORWARD &ACING&LATCH belt is stored. (see fig. c, pg. 39)

2Place rear-facingON VEHICLE SEATCEQUIPPED with LATCH anchors.

3&OROEASE OFAINSTALLATIONIEXTEND LATCH belt to its maximum length.

4(OOK CONNECTORSNTO VEHICLE LOWER ANCHORS

(fig. b). Belt must lay flat and not be twisted. Pull connectors to be sure they are securely attached to the anchor points. (fig. c).

50RESSEDOWN lRMLY INNCENTER OFLCHILDIRESTRAINTN while pulling LATCH adjustment belt. (fig. d).

60ULL FRONT TORBACK AND LEFT TO RIGHT ATABELT PATH TO CHECK FOR SECUREFINSTALLATION (fig. e).

#HECK#THAT THE LOWER ANCHORTBELT STAYS TIGHT and does not slip from the tightened position. If

IT DOESTNOTDSTAY TIGHTOTRYYANOTHEROSEATINGR POSITION ORICONTACTN#USTOMER 3ERVICE

7#HECK#LEVELCINDICATORVON CHILD RESTRAINT (fig. f).

Vehicle must BEBON LEVEL GROUNDVANDLCHILDRIN U CHILDCRESTRAINT WHEN CHECKINGILEVEL INDICATOR

Ball MUST be entirely in green zone (fig. f). If

NECESSARYPLACELROLLED TOWELSLUNDERDCHILDO RESTRAINT ATRVEHICLETSEAT CREASE UNTIL ENTIRE BALL A IS INIGREENIZONEG 4HENERECHECK LEVEL INDICATOR

DO NOT use tether rear-facing4ETHERHmustbe STORED SEE h4ETHERH3TORAGEv PAGER 

0ERIODICALLY CHECK THATYCHILDHRESTRAINTTIS SECURELYH INSTALLED AND PROPERLYALEVELED ADJUSTDIF NECESSARY

4OOREMOVE LATCHSEE h2EMOVING LATCH from 6EHICLE !NCHOR 0OINTSv PR 

16