32
B. Reinstall the flip-back armrests from the wheelchair.
Refer to INSTALLING/REMOVING FLIP BACK ARM-
RESTS in PROCEDURE 4 of the owner’s manual,
1081227.
MOUNTING PLATE - SEAT ANGLEADJUSTMENT AND INSTALLATIONORIENTATION (FIGURE 10)Seat Angle Adjustment
NOTE: The angle of the seat is factory set providing the user
with a 5
o
seat dump. This angle can changed by adjusting
either the front or back of the seat mount plate to obtain any
angle between 0
o
or 10
o
seat dump.
NOTE: There are three (3) heights of seat mounting plates;
low, medium, and high. See chart below for proper settings.
1. To obtain a 0o seat dump (DETAIL “A”):
A. Loosen the two (2) mounting screws that secure
the rear of the seat frame to the seat mount plate.
B. Position the mounting screws at the bottom of the
rear slot.
C. Securely tighten both mounting screws. T orque to
15-in/lbs.
2. To obtain a 10o seat dump (DETAIL “A”):
A. Loosen the two (2) mounting screws that secure
the front of the seat frame to the seat mount plate.
B. Position the mounting screws at the bottom of the
front slot.
C. Securely tighten both mounting screws. T orque to
15-in/lbs.
Installation Orientation
1. Medium and High Seat Mounting Plates: Install with
the angled end toward the front of the wheelchair.
2. Low Seat Mounting Plates: Install with the thicker
end toward the front of the wheelchair.
Mounting Screw
Mounting
Screw
Rear of Seat Frame
Medium Height
Seat Mount Plate
Angled End of Seat
Mounting Plate
LOW MEDIUM AND HIGH
Thicker End
DETAIL “A”
FIGURE 10 - MOUNTING PLATE - S EAT ANGLE ADJUSTMENT AND INSTALLATION ORIENTATION
MEDIUM
HEIGHT
HIGH
HEIGHT
LOW
HEIGHT
0o5o10o
SEAT DUMP
SEAT
MOUNT
PLATE FRONT OF
CHAIR
REAR OF
CHAIR FRONT OF
CHAIR
REAR OF
CHAIR FRONT OF
CHAIR
REAR OF
CHAIR
FRONT OF
CHAIR
REAR OF
CHAIR FRONT OF
CHAIR
REAR OF
CHAIR FRONT OF
CHAIR
REAR OF
CHAIR
FRONT
OF CHAIR
REAR OF
CHAIR FRONT OF
CHAIR
REAR OF
CHAIR FRONT OF
CHAIR
REAR OF
CHAIR
S
E
A
T
F
R
A
M
E
PROCEDURE 6 SEAT FRAME
Front of Seat
Frame