FWD WHEELCHAIRS | PROCEDURE 17 |
DEPTH
Flat Screws
FOOTREST ANGLE ADJUSTMENTS
WARNING
F
Two (2)
Washers Locknuts
DO NOT remove detent pin from footrest assembly. Otherwise, injury may result.
W D
Mounting
Positions
Footboard
ANGLE/HEIGHT
Side View Of 90o Footboard
Flat Screws
(Loosen
Here)
Washer/
Locknut
Half Clamp
Flat Screws
Washers
Locknuts
Footrest | Washer |
Support | Footboard |
|
Hub Cap
Locknut
Footrest Angle Adjustment Relative to the Vertical Position of the Front Shroud (FIGURE 16)
NOTE: The angle of the footrest relative to the vertical position of the front shroud can be increased or decreased by adjusting both cams located at the top of the footrest support.
1.Loosen the mounting screw and locknut that secure the cams to the upper mounting bracket. Refer to DETAIL “A”.
NOTE: Both cams MUST be rotated to the same posi- tion to keep the footrest square to the base.
2.Rotate both cams either direction until footrest is at desired angle. Refer to DETAIL “B” and “C”
3.Tightenmountingscrewandlocknutto12footpounds.
Footrest Angle Adjustment Relative to the Horizontal Position of the Front Shroud (FIGURE 16)
NOTE: The footrest is factory set to be square to the base when installed. The footrest can be positioned to be out of square by adjusting only one (1) of the cams located at the top of the footrest support.
1.Loosenthemountingscrewandlocknutthatsecurethe cams to the upper mounting bracket. Refer to DETAIL “A”.
2.Perform one (1) of the following:
NOTE: Right and Left are determined by sitting in the wheelchair.
A.Turningtherightcamwillrotatethefootrestcounter- clockwise. Refer to DETAIL “D”.
W H E E L C H A I R S
CaplugMounting Screw
| B. Turning the left cam will rotate the footrest clock- | |
FIGURE 15 - DEPTH/HEIGHT/ANGLE | wise. Refer to DETAIL “D”. | |
3. When footrest is at desired position, tighten mounting | ||
ADJUSTMENT | ||
screw and locknut to 12 foot pounds. | ||
|
103
