Graco PD220686A instruction manual Latch anchors, Maximumilength

REAR-FACINGINSTALLATION WITH LATCH

1LATCH belt must be routed through opening in child restraint for rear-facingmode.

(see page 29, fig. d 

Belt must lay flat and not be twisted.

2Adjust child restraint to recline position (see fig. a and page 25, fig. a 0LACEL rear-facingONOVEHICLEESEAT EQUIPPEDSWITH

LATCH anchors.

3&OROEASE OFAINSTALLATIONIEXTEND LATCH belt to its

MAXIMUMILENGTH

4(OOK CONNECTORSNTO VEHICLE LOWER ANCHORS

(fig. b). Pull connectors to be sure they are securely attached to the anchor points. (fig. c).

5Press down firmly in center of child restraint while pulling LATCH adjustment belt. (fig. d).

6

7

0ULL FRONT TORBACK AND LEFT TO RIGHT ATABELT PATHE TO CHECK FOR SECUREFINSTALLATION (fig. e) 4HE

CHILDIRESTRAINTESHOULD NOT MOVE SIDE TOUSIDE ORN FORWARD MORE THAN  INCHT CM 

#HECKETHAT THE LOWER ANCHORAGE BELTWSTAYS tight and does not slip from the tightened position. If it does not stay tight, try another

SEATINGTPOSITION OROCONTACTI#USTOMER 3ERVICE

#HECKELEVEL INDICATORLON CHILD RESTRAINT

Vehicle must BEBON LEVEL GROUND and child in

CHILDIRESTRAINTEWHEN CHECKINGTLEVELHINDICATOR

Ball MUST be entirely in blue zone (fig.f). If necessary, place rolled towels under child

RESTRAINT ATIVEHICLE SEAT CREASE UNTIL ENTIREEBALL IS IN BLUE ZONE 4HEN RECHECK LEVEL INDICATOR (see pages 24-25, fig. c 

DO NOT use tether rear-facing4ETHERHmustBE STOREDTSEE h4ETHERH3TORAGEv PAGER 

0ERFORM THIS TEST EVERYYTIME YOU DRIVE WITH YOUR child.

12