Graco PD220686A To ITS Maximum LENGTH, Press down firmly in center of child restraint to

FORWARD-FACING INSTALLATION WITH LATCH

1LATCH belt must be routed through opening in child restraint for forward-facing(see page 29, fig. e 

Belt must lay flat and not be twisted.

2Adjust car seat to upright position (see fig. a and page 25, fig. a  3ECUREERECLINE STANDAINTO 5PRIGHT 0OSITIONRBY PUSHING TABS INTO LOCK POSITION

Place forward-facingONOVEHICLEESEAT EQUIPPED with LATCH anchors.

3&OROEASE OFAINSTALLATIONIEXTEND LATCH belt

TO ITS MAXIMUM LENGTH

4(OOK CONNECTORSNTO VEHICLE LOWER ANCHORS

(fig. b). Pull connectors to be sure they are securely attached (fig. c).

53LIDEICHILD RESTRAINTDBACK UNTIL THE CHILD RESTRAINT IS IN CONTACTCWITH THE VEHICLE SEATHBACK

6Press down firmly in center of child restraint to

COMPRESS VEHICLE SEATECUSHIONLWHILESTIGHTENING

LATCH belt by pulling adjustment belt.

5SESYOUR KNEEUTO PRESS DOWN IN CENTERROF child restraint (fig. d).

70ULL FRONT TORBACK AND LEFT TO RIGHT ATABELT PATHE TO CHECK FOR SECUREFINSTALLATION (fig. e)4HE4

CHILDIRESTRAINTESHOULD NOT MOVE SIDE TOUSIDE ORN FORWARD MORE THAN  INCHT CM 

#HECKETHAT THE LOWER ANCHORAGE BELTWSTAYS tight and does not slip from the tightened position. If it does not stay tight, try another

SEATINGTPOSITION OROCONTACTI#USTOMER 3ERVICE

8!TTACH TETHER STRAPTHOOK (A) to anchor hardware (B) and tighten adjustment belt to

REMOVE ANY SLACK (fig. f).

Belt must lay flat and not be twisted.

0ERFORM THIS TEST EVERYYTIME YOU DRIVE WITH YOUR child.

14