Graco PD221760A ‡ Combination Lap/Shoulder Belt with Sliding Latch Plate, To Install Locking Clip

‡Combination Lap/Shoulder Belt with Sliding Latch Plate

Locking clip

This belt has a latch plate that slides freely along the belt.

This belt MUST be converted to prevent movement of the lap portion of the belt. You must use a locking clip (provided with the infant restraint) when using the infant restraint without the base unless your vehicle’s seat belt can be converted in another way as described in your vehicle owner’s manual.

To Install Locking Clip:		1/2 inch
1.	Tighten the buckled belt by pushing down	(1 cm)
	hard on the infant restraint and pulling hard
	on the shoulder belt.	™
2.	While pushing down on the infant restraint,
	pinch the two straps together behind the
	buckle tongue. Unbuckle the belt
	without allowing it to slip.
3.	Connect lap and shoulder belts with locking clip as
	shown ™ and š.	š
4.	Rebuckle belt. Check that lap belt does not
	move by pulling and push-
	ing hard on the infant
	restraint.
	If belt loosens or
	lengthens, repeat
	procedure.
	Locking clip goes here,
	1/2 inch (1 cm) from the buckle

18