Graco PD247308A owner manual FORWARD-FACING Installation with Latch

FORWARD-FACING INSTALLATION WITH LATCH

™

š

›

œ

Adjust child restraint to Upright position (fig. a). Flip recline feet out for forward facing use.

-AKE SURE 2EAR &ACING2LATCH belt is stored. (see fig. b, pg. 41)

Place forward-facingON VEHICLE SEAT EQUIPPED WITHELATCH anchors.

&OROEASE OFAINSTALLATIONIEXTEND LATCH BELT TOTITSTMAXIMUMTLENGTH

(OOK CONNECTORSNTO VEHICLE LOWER anchors (fig. b). Belt must lay flat and not be twisted. Pull connectors to be sure they are securely attached (fig. c).

3LIDEICHILD RESTRAINTDBACK UNTIL THE RESTRAINTRIS INNCONTACTSWITH THE VEHICLE SEAT BACK

Press down firmly in center of child restraint to

COMPRESS VEHICLE SEATECUSHIONLWHILESTIGHTENING

LATCH belt by pulling adjustment belt (fig. d).

ž0ULL FRONT TORBACK AND LEFT TO RIGHT ATABELT PATHE TO CHECK FOR SECUREFINSTALLATION (fig. e).

Ÿ#HECKETHAT THE LOWER ANCHOREBELT STAYS TIGHT and does not slip from the tightened position.

)F IT DOES NOT STAYSTIGHT TRYYANOTHEROSEATINGR POSITION ORICONTACTO#USTOMER 3ERVICE

!TTACH TETHER STRAPTHOOK (A) to anchor hardware (B) and tighten adjustment belt to REMOVE ANY SLACK (fig. f).

Belt must lay flat and not be twisted.

0ERIODICALLY CHECK THATYCHILDHRESTRAINTTIS SECURELY INSTALLEDIADJUST IFLNECESSARY

4OOREMOVE LATCHSEE h2EMOVING LATCH from 6EHICLE !NCHOR 0OINTSv PR 

20