Manuals / Graco / Baby / Car Seat

Graco PD247333A owner manual NOTE Free end of strap œ should face front of seat

Models: PD247333A

1 68

Download 68 pages 8.79 Kb

Page 56

3.NOTE: Free end of strap should face front of seat.

2.Pass the clip and the strap through the loop end as shown and pull strap up.

3.NOTE: Free end of strap should face front of seat.

56

Image 56

Graco PD247333A owner manual NOTE Free end of strap œ should face front of seat

Contents

Owner’s Manual READ THIS MANUALChild Restraint/Booster Seat Table of Contents Table of Contents cont 1.0 Warnings to Parents and Other Users 4. Properly routing the vehicle seat belt or LATCH 6. Properly securing your child in the child restraintGraco Children’s Products Inc Attn Customer Service 2.0 Registration InformationModel Number Date of Manufacture Purchase Date 2.1 Register Your Child Restraint2.3 If You Need Help 3.0 Useful Information 3.1&HUWLÀFDWLRQ3.2 Child Restraint Useful Life 3.3 Second Hand Child Restraint4.0 Features The locking clip is stored on the back of the child restraint. You will need to use it with certain types of vehicle seat belts 5.0 Assembling the Child Restraint Harness Strapthe seat exactly as shown in CLICK4. Attach 4 elastic loops from the seat pad under Page 7. The assembly is now complete 6.0 WARNINGS ‡DO NOT INSTALL OR USE THIS CHILD‡12&+,/5675$,17&$1*8$5$17 ‡NEVER LEAVE YOUR CHILD UNATTENDEDDO NOT USE THIS child restraint without properly assembling it is too large for built-in harness 7.0 Height and Weight Limitations7.1 WITH Built-In Harness 7.2 WITHOUT Built-in Harness Your child must meet all requirements ‡HLJKWWROEV7.3 WITHOUT Back Support 8.0 Choosing an Appropriate Vehicle Seat Location IMPROPER PLACEMENT OF THE CHILD RESTRAINT8.1 Vehicle Seat Location Requirements INCREASES THE RISK OF SERIOUS INJURY OR DEATH8.2 Vehicle Seat Belt Requirements 8.3 SAFE Vehicle Seat Belt SystemsMANY SEAT BELT SYSTEMS ARE NOT SAFE TO USE WITH THE CHILD RESTRAINT. THE VEHICLE SEAT BELT8.4 For Built-in Harness Only ‡ Lap Belts with Automatic Locking Retractor ALR8.5 With OR Without Built-in Harness When using booster seat WITHOUT the12” 1.25 cm 8.6 To Install Locking Cliprepeat above steps until secure ‡ Passive Restraint - Lap or Shoulder Belt Mounted on Door 8.7 UNSAFE Vehicle Belt Systems‡ Lap Belts with Emergency Locking Retractor ELR DO NOT use these seat belts ‡ Passive Restraint Lap Belt with Motorized Shoulder Belt‡ Lap Belts Forward of Seat Crease 9.0 LATCH 9.1 What is LATCH? Typical seat in a 9.2 LATCH System Vehicle Top Tether Child RestraintTop Tether Anchor PointFOR YOUR CHILD INCREASES THE RISK OF SERIOUS 10.0 Using Child Restraint WITH Built-in HarnessFAILURE TO PROPERLY ADJUST THE HARNESS STRAPS œ ž 3. Unbuckle harness straps œ5. The harness straps must go into the slots HYHQZLWKRUMXVWDERYHWKHVKRXOGHUV ŸIf straps are in proper slots go to page 6.7RDGMXVWKDUQHVVVWUDSVPage Harness strapsMUST go overPage 11.1 Using a Child Restraint WITH a Built-in Harness 11.0 Securing the Child Restraint in Your Vehicle11.2 With a Vehicle Lap or Lap/shoulder Belt Lower anchors must be stored when using vehicle beltRFDWLRQS 6. Safety Check for Secure Installation4. Tighten vehicle seat belt 11.3 With LATCH lay flat and not be twisted8. Safety Check for Secure Installation 12.0 Securing Your Child in the Child Restraint ‡Avoid bulky clothingFAILURE TO PROPERLY SECURE YOUR CHILD IN THE CHILD RESTRAINT INCREASES THE RISK OF SERIOUS INJURY ORFOLSDWPLGGOHRIFKLOG¶VFKHVWOHYHOZLWK 3. Fasten harness clip š. Position harnessarmpits 13.0 Harness Removal or Re-attaching Harness 1. Remove harness straps4. Grab the crotch strap buckle and pull it completely out œ Remove body support and crotch padPage Harness Strap Arm T-slotRepeat on other side 14.0 Using Your Child Restraint WITHOUT Built-in Harness FAILURE TO PROPERLY SECURE YOUR CHILD IN THE CHILDRESTRAINT INCREASES THE RISK OF SERIOUS INJURY OR DEATH IN THE EVENT OF A SHARP TURN, SUDDEN STOP ORINCORRECTINCORRECT INCORRECTINCORRECTINCORRECT INCORRECT ™ š › 15.0 Securing Child & Booster Seat in Vehicleharness 16.0 Adjusting Head SupportWhen using with or without the built-in 17.0 Removing or Re-attaching Back Support To use booster seat WITHOUT back1. Detach 2 lower elastic straps from rear of seat as shown ™ VXSSRUWUHPRYHKDUQHVVVWUDSVLIDWWDFKHG4. Move seat pad fabric out of the way and Page 18.0 Securing Child in Vehicle with Shoulder Belt Positioning Clip 3. NOTE Free end of strap œ should face front of seat REAR VIEW OF CHILD SITTING IN SEAT CORRECT 19.0 Using the Tether 19.1 Storing Lower Anchors and Tether LATCH 20.0 Airplane Use Important points to rememberplacement of the chest clip at armpit level 21.0 Accessories on certain models ONLY21.1 Body Support & Harness Covers 21.2 Body Support & Harness Covers š ™ › 22.0 Recline Foot23.0 Care and Maintenance 23.1 Buckle Cleaning Process 3UHYHQWVHULRXVLQMXU\RUGHDWK24.0 To Remove or Re-attach Seat Cover BLEACH26.0 Replacement Parts and Warranty please contact us at the following