Setup
gun |
|
connection |
hose
hose rack
inlet water |
| |
connection |
| |
3/4” garden | TI1262A | |
hose | ||
|
Check for Shipping Damage
Check the pressure washer for shipping damage. If anything is damaged, notify the carrier immediately.
Set Up
Connect the
CAUTION
Up to 100 ft (30 m) of
Install the appropriate spray tip on the wand. See Installing and Changing Spray Tips on page 6. If you use a sandblaster kit, see its separate manual for installation instructions.
Connect to Water Supply
CAUTION
Before you connect to the water supply, check your local plumbing code regarding cross connection to the water supply. Backflow Preventer 801133 is available to prevent backflow of contaminated water into the fresh water supply. Install it upstream from the pump.
If inlet water pressure is over 60 psi (414 kPa,
4.1bar) Regulating Water Valve 800258 must be installed at the garden hose connection.
Do not exceed 160_ F (70_ C) inlet water temperature.
Connect a hose with at least a
NOTE: The water source must have a minimum flow rate equal to that of the pressure washer. See Technical Data on page 15.
4 308524