Graco TI12743a, TI12954a 15V202 Third Flush Valve Kit for RoboMix, 15V822 Kit Installation

Installation

1
10	T
2	3
	6					TI12655a
	5		Dump		Dump
	V	8	Valve B		Valve A
				4

11

	9
TI13045a	TI13047a

FIG. 7: 15V822 Kit Installation

15V202 Third Flush Valve Kit for RoboMix

1.Shut off the air and fluid supply to the ProMix 2KS.

2.Relieve pressure. See your ProMix 2KS Operation Manual.

3.See FIG. 8. Remove the plug (A) from the air flush valve (AFV). Install an o-ring (6) in this port.

4.Install the third flush valve adapter (3) in the Robo- Mix. Ensure that the o-ring (6) remains in place to seal between the adapter and the air flush valve adapter.

5.Secure the adapter (3) to the air flush valve adapter with four screws (10) inserted through the side wall of the RoboMix. Torque to 70 in-lb (8 N•m).

6.Apply thread sealant and install the check valve (4) through the back of the RoboMix and into the third flush valve adapter (3).

7.Install the o-ring (2), seat (1), o-ring (6), and third flush valve (5) in the adapter (3).

8.See FIG. 8. Shut off all power to the fluid panel. Open the fluid panel. Install the solenoid (8) in the third flush valve position on the solenoid manifold. Install the tube connector (9). Connect the solenoid wires to the fluid panel control board as shown in FIG. 3. Also see the System Electrical Schematic on page 13.

9.Connect the tubing (13) between the solenoid mani- fold and the tube fitting (T) on the third flush valve

(5). See System Pneumatic Schematic, page 10.

10.Connect the third flush fluid supply line to the check valve (4).

312786G 7