Service
WARNING
SKIN INJECTION HAZARD
To reduce the risk of serious injury, whenever you are instructed to relieve pressure, follow the Pressure Relief
Procedure on page 4.
Swivel Repair
1.Relieve the pressure.
2.Unscrew the swivel stud (21) from the gun. Re- move the spring (22), glands (24†, 25†), and packings (23†) from the swivel housing (26). See Fig. 4.
3.Clean all parts and inspect. The ball bearing in the swivel stud should rotate freely. Replace any worn or damaged parts.
NOTE: Repair kit 207308 is available for the swivel. Use all the parts in the kit for the best results.
4.Install the spring (22), male gland (24†) and five
Needle Adjustment
WARNING
Proper adjustment of the needle is essential to be sure the trigger safety latch makes the gun inoperative when engaged. Improper adjustment may allow the gun to be triggered, even with the trigger safety latch engaged, resulting in serious injury, including fluid injection and splashing in the eyes or on the skin.
1. | Relieve the pressure. Disconnect the hose. |
2. | With the trigger safety latch (29) engaged, |
| squeeze the trigger. There should be about 0.125 |
3.To adjust, remove the tip guard or nozzle exten- sion. Release the safety latch. Squeeze the trigger and loosen the locknut (4). Insert the wrench (3) into the tip of the needle (10) and turn it in or out until the proper free play is obtained. Tighten the locknut (4).
4.Install the tip guard. Start the system. Trigger the gun and release; fluid flow should stop immediate- ly. Now engage the trigger safety latch. Try to trigger the gun; no fluid should flow. If the gun fails either test, relieve the pressure and re- adjust the needle.
22
24†
23†
25†
21
8124
Fig. 4
4
10
3
in. (3.18 mm) free play at the end of the trigger. |
See Fig. 6 on page 10. |
Fig. 5
8102
307010 9
