Graco Inc 02017, 308-293, M-1265

308–293 31

Notes

Contents

Main 308293 INSTRUCTIONS-PARTS Model Optimiser HVLP Spray Gun Table of Contents Symbols Warning Symbol Caution Symbol WARNING PRESSURIZED EQUIPMENT HAZARD FIRE AND EXPLOSION HAZARD TOXIC FLUID HAZARD TERMS: Standard CHART 1: GUN ASSEMBLIES, Series B Gun Assemblies (See TERMS above) Gun Assemblies available as Build to Order Standard See page 6 for needle assembly replacement tips. recommended torque to install molded fluid nozzle in the spray gun is 35 in-lbs (4 N * Maximum See CHART 3: OPTIONAL ORIFICE PURGE SST NEEDLE Use CHART 4: NEEDLE ASSEMBLY REPLACEMENT TIPS Selecting the Proper Needle/Nozzle/Air Cap Set Selection Problems and Solutions Air Flow and Atomizing Pressure Air Flow Atomizing Air Pressure Typical Installation The M-1265 HVLP Spray Gun Ventilate the Spray Booth 1. Connect the Air Line If your regulated air source does not have a filter , 2. Connect the Fluid Hose 3. Flush the Spray Gun. 4. Relieve the Pressure. 5. Position the Air Cap (continued) Continued on the next page. For continuous spraying, Page Operation Pressure Relief Procedure Applying the Fluid WRONG RIGHT General System Maintenance Page Page Page Troubleshooting Page Items Needed for Service Disassembly Page Assembly Page Parts Drawing Parts List Manual which may be purchased separately Repair Kit 236007 100 psi (0.7 MPa, 7 bar) Maximum Inlet Pressure 330 psi (21210 kPa, 0.22.1 bar) Regulated Pressure Range 100 psi (0.7 MPa, 7 bar) Maximum Working Pressure 300 psi (2.1 MPa, 21 bar) Maximum Working Pressure 250 psi (1.7 MPa, 17.4 bar) Maximum (with check valve) Dimensions Technical Data Page Page Page Graco W MINNEAPOLIS, MN GRACO INC. P.O. BOX 1441 All Graco 32 308293 arranty and Limitation of Liability Phone Numbers , or call this number to identify the distributor closest to you: 18003674023 T