General Repair Information
General Repair Information
To reduce risk of serious injury, do not touch moving parts with fingers or tools while testing repair. Shut off sprayer when repairing. Install all covers, gaskets, screws and washers before operating sprayer
1Keep all screws, nuts, washers, gaskets, and electrical fittings removed during repair procedures. These parts are not normally provided with replacement assemblies.
2Test repair after problem is corrected.
3If sprayer does not operate properly, review repair procedure to verify procedure was done correctly. If necessary, see Troubleshooting Guide, page 7, for other possible solutions.
4Install belt guard before operation of sprayer and replace if damaged. Belt guard reduces risk of pinching and loss of fingers; see preceding WARNING.
Grounding
SAE O-Ring Installation
1 Unscrew lock nut to touch fitting.
2 Lubricate
A
ti5414a
3 Screw in fitting hand tight.
ti5415a
4 Unscrew fitting until oriented properly.
ti5416a
Ground sprayer with grounding clamp to earth ground for safe sprayer operation when using
5Tighten lock nut to indicated torque. (Make sure washer is seated properly without pinching
ti5417a
6250
FIG. 1
6 | 311797J |
