,
::
REMOVE TAPE
FROM PUMP CAP
I
SPRAY
GUN
!’
\SPRAY HOSE
. .. .
r . . :,
, ...
L:’: ..~,<
Check Electrical Service and Plug In
Before plugging in thesprayer. besure the electrical service is3 phase 220V, 60 HAC.20Amp. With the
m)long.
Install Hose and Spray Gun
Connect the spray hose tothe spray gun by inserting thepin at theend of the hose intothe quick disconnect coupler on the gun. Connect the hose to the fluid outlet in thesame way.
Remove the tape from the cap on top of the pump.
Cleaning Accessories
For spraying detergent or other cleaningsolution, we
recommendusing a chemicalinjecior kit. See
Accessories and
For removing rust and old paint we recommend using a water sandblaster.See Accessories and instruction manual
Connect To W a t e ~Supply
Do not exceed 16OoF (7OOC) ,water temperature to pump in a direct supply system.
Connect a hose with at least a 3/4 in. (19 mm) ID from your citywatersupply to theunit’s 3/4 in. garden hose threaded inlet. The supply hose should not be more than 50 ft. (15 m) long.
NOTE: For a directsupply system. your water source at the unitmusthave a flow rateof
AT LEAST 5 GPM (19 LITER/MIN).
If your operating conditions are different fromabove, contact our Customer ServiceDepartmentfor assistance.