Refer tothe engine instructionbookletprovidedwith the unit.
Install Wheels and Handle
Slide the axle into theframe. Slide the wheels onto the axle and secure with the 1/2 inch locknuts provided.
Attach the handle with the 4 screws, nuts, flat washers and lockwashers provided.
Install Hose and Spray Gun
Connect the spray hose to the spraygunbyinserting the pin at the end of thehose into the quick disconnect coupler on the gun. Connect thehose to the fluid outlet in the same way.
Remove the tape from the cap on top of the pump.
Cleaning Accessories
For sprayingdetergentorothercleaningsolution, we
recommendusingachemicalinjectorkit.See Ac- cessories and instruction
For removing rust and old paint werecommend using a
watersandblaster. SeeAccessories andinstruction manual
Connect To Water Supply
C A U T O N
Beforeattaching to water supply,check local
water supply.
Do not exceed160" F (70" C) watertemperature to pump in a direct supply system.
Connect a hose with at least a 3/4in. (19 mm) ID from your city water supply to the unit's 3/4 in. garden hose threaded inlet. The supply hose should not be more than 50 ft. (15 m) long.
NOTE: For a direct SUDO~V svstem. your water source at the unct 'must'have a flow rate of
AT LEAST5 GPM (19 LITER/MIN).
Ifyouroperatingconditions are different from above. contactourCustomerServiceDepartmentfor.
assistance.
