Full-electric bed only (US0458 / US0458PL):

Assemble hi/lo motor shaft to foot end gear box

FOOT

hi/lo motor

 

END

 

notches in hi/lo motor shaft coupler

 

slide over gear box shaft pin

 

gear box

hi/lo motor shaft

Attach hi/lo motor shaft

to foot end gear box

You must first attach the coupler end of the motor shaft to the foot-end gear box (see above).

1.Note the position of the hi/lo motor plug on the Okimat actuator next to the pendant hand control plug — plug the hi/lo motor into the actuator, routing the hi/lo motor cord under the fixed base frame cross-angle as shown below to ensure clearance with the hi/lo drive shaft.

2.Plug the power cord into any grounded outlet.

3.Pull the motor shaft toward the foot end. Using the hi/lo function on your pendant hand con- trol, slowly turn the hi/lo motor shaft until the coupler matches up with the gear box shaft pin as shown above.

4.Slide the coupler until it rests completely on the pin. You may need to manipulate the foot end slightly from side to side and/or lift the hi/lo motor itself for proper alignment.

5.Unplug the power cord.

HEAD

FOOT

Route cord under cross-angle

US0208-INS-LAB-RevD11 • Patriot Homecare Bed

12

Page 12
Image 12
Graham Field US0208PL, US0458 user manual Unplug the power cord